HPX 13701 is designed for masking surfaces where high chemical or thermal resistance is required. Great for splicing.

Supplied in a roll with length 66m .

Roll width according to customer's request.

The maximum possible width is 710mm.

The tape withstands temperatures of +180°C (up to 30 minutes +220°C) and leaves no adhesive residue when removed.

Easy to apply, easy to remove.

Applied one time.

Can withstand multiple heating-cooling cycles.

PET base and silicone adhesive: the tape is resistant to solvent-based solvents, acids and alkalis.

Tape 13701 HPX is used for temporary fixing of parts on products during transportation with subsequent removal without traces of glue on the surface of products and parts.

Also, it is widely used as a protective tape for high-temperature painting of parts.

Applications:
Powder Coating
Anodizing
Electronic Assembly
Circuit boards
Battery packs
Photo Splicing
Sublimation Printing
Cerakote Painting
Automotive wheels Painting
Resin Molding
Plating

Adhesion to materials:

Plastics, rubber, glass, metal.

Instructions for use:

Glue at temperatures from +15 to +30˚С

The surface must be clean, dry and free of grease. Use isopropyl alcohol to degrease.
When finishing a high-temperature project, remove the tape at 90 Degree angle while surface is still hot for it to leave 0 to little residue.
Store tape rolls in a temperature and humidity controlled location for best results.

After applying, press the tape as hard as possible with your hand for 2 seconds to activate the adhesive layer.

ATTENTION!!! IMPORTANT!!!

These recommendations are based on the experience of our employees, are provided for informational purposes and do not constitute an official guarantee.

The buyer independently checks the suitability of the goods for their intended use.